scuffing

英 [ˈskʌfɪŋ]

美 [ˈskʌfɪŋ]

v.  磨损; 磨坏; 拖着脚走
scuff的现在分词

现在分词：scuffing　

柯林斯词典

• V-ERG (使)磨损;(使)磨坏
  If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.
  1. Constant wheelchair use will scuff almost any floor surface...
     任何地板上经常有轮椅走动几乎都会有所磨损。
  2. Molded plastic is almost indestructible, but scuffs easily.
     注塑几乎弄不坏，但是容易磨损。
• VERB 拖着脚走
  If youscuffyour feet, you pull them along the ground as you walk.
  1. Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
     波莉既困惑又尴尬，低下头拖着脚走开了。

双语例句

• Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive
  齿轮传动抗胶合模糊可靠性分析与计算
• This paper provides some theoretical basis for further studying the mechanisms of boundary film formation, wear and scuffing.
  这为进一步计算等温应力与热应力场打下了基础，也为研究边界膜成膜，磨损及表面胶合机理提供了一定的理论依据。
• The anti scuffing, friction reducing and wear resistant properties were investigated systematically on a pin on disc tester under engine oil lubrication condition.
  用销盘试验机在机械油润滑条件下对渗硫表面的抗擦伤性能，减摩及耐磨性能进行了系统研究。
• They are the scuffing bricks and moder of the nests.
  他们是搬运砖块与筑巢的专家。
• The coatings has good antifogging property as well as good transparent and resistance to scuffing property.
  实验结果表明，该涂料具有优良的防雾性能，以及优良的透明性和抗擦伤性。
• Standard test method for scuffing load capacity of gears
  GB/T13672-1992齿轮胶合承载能力试验方法
• Hot load and mechanical load coupling make piston to produce crackle, piston-ring glued and scuffing of cylinder bore and so on.
  热负荷和机械负荷耦合将导致活塞产生裂纹、活塞环胶结以及拉缸等。
• At the end of the service, King paraded up the aisle with the choir, his robe scuffing the floor.
  在仪式要结束时，金与唱诗班列队走上了过道，他的长袍拖到了地板。
• The research method adopted in the paper are fo some significance to the study of gear scuffing mechanism and the study to increase the gear scuffing load carry capacity.
  本文的研究方法对齿轮胶合机理和提高齿轮胶合承载能力的研究都是有意义的。
• The experimental results showed there exists influence of the oil temperature on the scuffing resistant.
  试验结果表明：供油温度对摩擦副的抗咬死性能有较大的影响。