pawl
英
美
网络 棘爪; 制转杆; 掣爪; 卡爪
复数：pawls
英英释义
noun
- a hinged catch that fits into a notch of a ratchet to move a wheel forward or prevent it from moving backward
双语例句
- Design characteristics of pawl pole permanent synchronous machine
爪极永磁同步电机的设计特点 - The pawl type bamboo roots grab was designed.
竹爪式竹根挖掘机方案设计。 - A toothed wheel or rack engaged with a pawl that permits it to move in only one direction.
连接着棘爪的只能允许朝一个方向运动的齿轮或齿轮架。 - And adjusting the friction torque between the ratchet wheel and pawl can effectively increase the code discrimination performance of micro-electromechanical system code lock.
通过控制棘轮棘爪处的摩擦力矩可有效提高微机电系统密码锁的鉴码性能。 - Ratchet mechanism is often used in the reducer of the casting crane. This paper uses Pro/ ENGINEER software to create the ratchet mechanism and simulate its running and studies the stress and deformation of the ratchet wheel pawl by Pro/ MECHANICA.
针对铸造起重机用减速器常采用的棘轮装置，采用三维实体造型软件Pro/ENGINEER建立其实体模进行运动仿真，利用Pro/MECHANICA有限元分析模块对棘爪进行应力、应变分析，得到棘爪需加强的部分。 - The virtual prototype of the clutch is built based on Pro/ E and the switch process of the SSS clutch is simulated by MSC Adams. The simulation of the impact performance of the pawl and pawl wheel and the engaging performance of the middle part is finished.
利用Pro/E及MSCADAMS建立该离合器的虚拟样机模型，并在MSCADAMS中对离合器动态接合过程进行仿真，分析棘轮棘爪的碰撞特性，以及中间件的啮合特性。 - This paper introduces the structure and design characteristics of pawl pole permanent synchronous machine, and illustrates the relations among main structure sizes.
介绍爪极永磁同步电机转子的结构及设计特点，并说明了一些主要结构尺寸间的关系。 - The fastening tool further includes a coil feeder ( 720) assembly having an indexing pawl ( 722).
紧固工具还包括具有分度棘爪的卷料进给组件。 - This paper deels with the filling density calculation and design methods to determine the num-bers of the pawl and teeth of the ratchet wheel as well as linkage lengths of the mechanism.
本文对该机构的纬密计算，棘爪数、棘轮齿数以及传动连轩长度的确定等设计方法均作了较为详细的介绍。 - The fine blanking dies of the pawl and the chute used for the seat recliner were firstly introduced in this thesis, and failure analysis has been carried out in view of mechanical calculation, metallographic test, hardness test and SEM.
本文首先针对棘爪、滑槽板两副精冲模具出现断裂的凸模，从力学强度校核、金相试验、硬度试验、断口电镜扫描等进行试验分析。