deflections

英 [dɪˈflɛkʃənz]

美

n.  (尤指击中某物后)突然转向，偏斜，偏离
deflection的复数

柯林斯词典

• N-VAR 偏斜;偏转
  Thedeflectionof something means making it change direction.
  1. ...the deflection of light as it passes through the slits in the grating.
     光线通过光栅狭缝时的偏转
• (体育运动中球击中某物后的)转向，变向
  In sport, thedeflectionof a ball, kick, or shot is when the ball hits an object and then travels in a different direction.

双语例句

• Analysis to Large Deflections of Elastic Cantilever Beam with Constraint under Uniformly Distributed Load
  均布载荷下变形受约束悬臂梁弹性大变形分析
• The deflections of the vertical happen to be known in this case ( see below).
  垂直偏斜碰巧在此例中有证明（看下图）。
• The deflections of the blades under different wind speeds and different rotating time were given to validate the reliability of the model presented herein.
  研究结果对风力机叶片的振动特性和疲劳寿命预测以及高性能叶片的设计有理论指导意义。
• When aerodynamic solution and structural deflections are both converged, the aerodynamic characteristic of the elastic wing is obtained.
  将非线性气动力与结构线化机翼弹性变形耦合迭代求解。
• However, while some building codes provide methods for estimating shear wall deflections, these methods are not adequate for shear walls without hold-downs.
  尽管有些国家的建筑规范中已给出了估算木结构剪力墙侧向变形的方法，但这些方法并不适用于无抗倾覆锚固件木结构剪力墙。
• The results showed that: both two maximal deflections were at the middle point of end span;
  发现两者最大挠度都发生在受火边跨；
• In geometric nonlinearity, the effects of instability produced by axial forces, the bowing of the deformed members, and finite deflections have all been included.
  在几何非线性的影响下，所产生不稳定的轴向力、弯曲变形产生的弯矩，以及有限制的偏移量均包括在内。
• An increase in resistance to roll deflections may be gained by splitting the single strut into a fork at the top.
  采用上部分呈叉状的单支杆可以增强抗滚转变形性能。
• In this paper, a new method to measure meshing composite deflections of loaded cylindrical involute helical gear by using high precision clinometer is presented.
  提出利用高精度测角仪测量齿轮副在啮合过程中不同啮合位置时轮齿受载综合变形的新方法。
• Where required, to examine deflections, stiffness requirements, and any special material and design provisions to obviate brittle fracture under adverse conditions.
  必要时验算挠度、刚度要求、以及任一特殊材料和设计规定，以预防不利条件下的脆断。