chamfer
英 [ˈtʃæmfə(r)]
美 [ˈtʃæmfər]
n. 斜切面; 削角
复数：chamfers 现在分词：chamfering 过去分词：chamfered 过去式：chamfered 第三人称单数：chamfers
COCA.44768
牛津词典
noun
- 斜切面；削角
a cut made along an edge or on a corner so that it slopes rather than being at 90˚
英英释义
noun
verb
双语例句
- Select those front edges and chamfer them then click apply and chamfer it again but this time with a lower value.
选择前面的边并倒角，然后单击应用并以较低的值再次倒角。 - This paper analyzes the lack of traditional settingout method and the advantage of digitalization settingout method when analyzing settingout of chamfer stake in cubic meter of earth and stone.
分析了土石方工程中坡口桩放样时，传统放样方法的不足和数字化放样方法的优点。 - What is the nominal chamfer size?
什么是公称倒角尺寸？ - RECHAMFER: Defect on radii and chamfer; defective chamfer such as nicks that are considered to be repairable.
重新倒角：可被重新修复的倒角缺陷，例如划痕。 - After too large tooth resultant force is eliminated, tooth chamfer bone is OK proper motion rehabilitate, of the tooth become loose degree also return to normal subsequently;
当过大的牙合力消除后，牙槽骨可以自行修复，牙齿的松动度也随之恢复正常； - Rolling bearing chamfer dimension limits
GB/T274-1991滚动轴承装配倒角极限 - Also, the chamfer of the stay vanes entrance and the surface roughness of the flow channel were optimized by the numerical investigations.
亦对固定导叶入口冲角、涡壳壁面粗糙度对流动的影响进行了定量分析。 - The specialized inspector inspects the bore diameter, pitch, chamfer and finish degree of bore wall.
加工完成后由专门检验员检验孔径、孔距、倒角大小、孔壁光洁度。 - Fit the sealing ring at the correct position in the vacuum pump so that it is flush with the lower edge of the chamfer in the rotor.
将密封圈安装在真空泵的正确位置，以便密封圈与转子倒棱的下边缘平齐。 - Carefully remove smaller edges or burrs on the chamfer of the crankshaft flange with an oilstone if necessary.
如有必要，请用油石仔细去除曲轴法兰倒棱上的小边或毛刺。