asperities

英 [æsˈpɛrɪtiz]

美 [əˈspɛrɪtiz]

n.  (尤指语言、态度)粗暴，严厉
asperity的复数

双语例句

• The relationship between sliding friction force and contacting condition of rough surfaces was developed according to kinematics and dynamics analysis of two contacting asperities.
  从一对微凸体的接触力学和运动学分析出发，建立了非流体动力润滑条件下粗糙表面滑动摩擦阻力与粗糙表面接触状态间的关系。
• Merchant thought that minute asperities existed at the chip-tool interface and the fluid was drawn into the interface by the capillary action of the interlocking network of these surface asperities.
  Merchant认为：在切屑与刀具接触界面上存在微小的粗粒，切削液通过这些表面的微小粗粒组成连锁的网络的毛细管被吸入到切屑与刀具的接触界面上。
• However, at higher angle of tooth-shaped asperities and under higher normal stress, the failure model II is found, which is in first tension but final shear failure.
  在较高的法向应力下，含起伏角较高齿形节理面的非贯通节理岩体可能出现破坏模式II（先张拉后剪切破坏模式）。
• If the gouge layer is thin, contact between asperities on the rock surfaces can occur.
  如果充填物层很薄，两个岩石表面上的凸起物就有可能互相接触。
• The highest temperature of asperities is much higher than that of worn plane, which is one of the main factors in leading to stress graphitization on worn surface.
  摩擦过程中粗糙表面微凸体的最高温度远大于摩擦平面，瞬时的高温和摩擦剪切力的作用使微凸体被应力石墨化。
• Agglomerates of delusterant particles located near the surface of sythetic fibers cause asperities.
  消光剂颗粒集结在合成纤维表面附近，导致表面粗糙。
• The preparation and nucleation of a strong earthquake involve fracturing of asperities on the fault plane, and the foreshock activity, the dynamic rupture process and the precursors of the strong earthquake depend on the scale, the strength and the number of asperities.
  强震孕育过程中包含着凹凸体的破裂，断层面上凹凸体的尺度、强度及数量决定着前震活动的特征、强震动态破裂过程以及前兆现象。
• The influence of density distribution and height of the asperities on nonlocal friction is also studied here. A experimental system for friction test is designed.
  分析了微凸体分布密度不同、微凸体高度不同时，非局部摩擦的影响变化规律。
• Based on the interaction of asperities and upper-bound approach a mathematical model for simulation of friction phenomenon between dies and workpiece was proposed.
  本文中以刚性微凸体与可变形微凸体的相互作用模拟金属压力加工过程中模具与工件之间的摩擦过程，并用上限法分析所提出的模型。
• Numerical results reveal that the existence of single asperities can lead pressure to change drastically and film thickness to become thin in the vicinity of the asperities.
  结果表明，单粗糙峰造成接触区对应位置油膜压力剧烈变化而膜厚变薄。